Use single ended inserts when parting or grooving to depths greater than 19mm.
Use double ended inserts for cutting up to 19mm deep.
The two cutting edges offer an economical solution for parting and grooving.
J type chip breaker
» Range (width of cut): 1.4, 2, 3, 4, 5, 6mm
- For soft materials, parting off tube, small diameters and thin-walled parts
- Low forces and smaller burrs
- Improved straightness
- Low-to-medium feeds
C type chip breaker
» Range (width of cut): 2, 3, 4, 5, 6, 8mm
- For hard materials and tough applications
- For general applications on steel, alloy steel and stainless steel
- Medium-to-high feeds